Authorized warehouse and distribution center for
CEG Metric Electric Motors
CEG is a high quality line of metric AC motors. Our warehouse in Kalamazoo Michigan holds an extensive inventory of common ratings. CEG can replace 95% of the metric motor aftermarket . This includes 230 / 430 Volt as well as 575 volt. We also have B-5 (D-Flanges), B-14 (C-Flanges) and off standard as well.
We can help reduce overseas freight costs - reduce your downtime and increase your bottom line
Multi-Mount, With Pre-Tapped Holes from 63 to 180 Frame Allowing Configurations (F1, F2, F0)- Removeable Feet - 63 to 180 Frame
- IP55 Enclosure Washdown with Pressure Hose
- 1.15 Service Factor
- EPACT Approved CE UL and CSA - ISO9001
- Full Range of Increased and Reduction Flanges (Some Sized Require Shaft Modification to Install)
- Suitable For Inverter Duty 10:1 Variable - 4:1 Constant (80 Frame and Above)
|
3-Phase
- Type MTEPS - High Efficiency
- 1 - 30HP 90L to 180L Frame are EPACT Approved
- 200L FR and Higher Will Follow (Cast Iron)
- Type MTOML - Standard Efficiency
- 56 to 80 Frame and Increased Output Motors
- Type DPOML - Two Speed
- Standard and with Brakes
|
 |
|
1-Phase
- Type MMDSG/DMDSG
- High Starting Torque: .5 to 3.5 HP - 63 to 100 Frame 2 and 4 Pole
- CAP Start CAP Run - Industrial & Agricultural Applications
- Type MMOML/DMOML
- Low Starting Torque: .5 to 3.5HP - 56 to 100 Frame 2 and 4 Pole
- Permanent Capacitor - Fans Blower Applications
- Single Voltage of 110V or 230 V
- Dual Voltage 115/230V
|
 |
|
Brake Motors
- Type MTFHC
- Standard 3-phase with Lenze Brakes 2, 4, 6 and 8 Pole
- CAP Start CAP Run - Industrial & Agricultral Applications
- Type DPFHC
- Two Speeds, 3-Phase with Lenze Brakes
- Type MMFHC
- 1-Phase Design With Lenze Brake
- Also Available From Factory Compact (Gradual) Brakes and High Torque AC Brakes
|
 |
|
Arbour Saw Motors
- Type EMOML and ETOML
- 1-Phase and 3 Phase Arbour Saw Motors
- Suitable For Himmel Replacements
- Compact Brakes Available
- Key Shaft or Locking Collars
- Specify Left or Right Hand Thread
- Mounting with Slots in Body
|
 |
|
Flanges
- Standard B5 and B14
- B14 Increase Flanges
- B5 and B14 Reduction Flanges
- Custom Flanges or Adaptor Plates Available
|
 |
How To Identify:
C Flange
Threaded Holes For Mounting
D Flange
Always Bolt Through
3 important dimensions to measure are the P, N, and M dimensions in millimeters
 |
 |
 |
 |
| Alternative |
Flanges
|
 |
 |
